Yellow cap motor part's

[Kevin Taylor]

I am trying to revive a tsugami chucker with a 3T fanuc and I have found the Z axis motor to have the brush holder thread's damaged and the brush missing I think this might explane the alarm on this slide does anyone have a broken or burnt up motor I might buy for part's P.M. Email or call Kevin Taylor
712-527-4625 ktaylor253@earthlink.net Thank's P.S. Could use a pinout and set up for a RS32 cable for the same machine?

[Al_The_Man]

You could try Helwig Carbon, they supply the brushes, they may have brush holder also, it would be worth a try, Also the Getty's motors were identical, (some early Fanuc were actually Gettys anyway).
Al.

[Kevin Taylor]

Al I got the motor reinstaled today and now I have the alarm again I don't understand how I could have it joging X&Z and the spindel and now I have the alarm again 06860 Servo alarm 02[VRDY OFF] and the HCLV light on the board lit up I switched the board's and the problem seem's to stay with the board I have a mill with the 3M control spotted for part's if the board's are the same # I think i might try to get it for spair part's any other ideas would be great Thank's Kevin