Mori w/10T - CNCzone.com-The Largest Machinist Community on the net!

grease · #1 10-25-2007, 04:36 PM

We replaced master board and loaded parameters. The problem is the machine will not run a program.

Machine: Mori Seiki AL-2A
Control:10TF

Any help on this would be appreciated.

Grease

dcoupar · #2 10-25-2007, 10:56 PM

Just out of curiosity...

Can you MDI in a command and cycle start it successfully?

Are there any alarms?

grease · #3 10-26-2007, 05:10 PM

Thanks for your reply.
The problem was the tailstock interlock.

Thanks,
Grease

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mori-Seiki SL-3H	B_Bueno	General Metalwork Discussion	1	12-20-2011 09:00 AM
mori seiki?	manuelc149	General Metal Working Machines	10	10-24-2007 06:15 PM
Mori Seiki SL-204	dcworld	General Metal Working Machines	1	07-27-2007 10:25 PM
Mori Seki SL4	programmer1956	Mazak, Mitsubishi, Mazatrol	3	03-08-2007 04:22 PM
mori	dj stu	Post Processor Files	3	03-17-2005 12:14 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)