I/O unit - CNCzone.com-The Largest Machinist Community on the net!

guhl · #1 08-16-2007, 07:32 AM

Good day.
May be anybody has manual for I/O unit BU04A? I wanna know how to move to desired page in the LAD program. And is it possible to make changes in the LAD without any special equipment?
Best regards, Viktor

bborb · #2 08-17-2007, 07:23 AM

The ladder usually has search capabilities.
You cannot change the ladder without special stuff.

guhl · #3 08-20-2007, 01:32 AM

There are two menu items: "search-w" and "search-m". But I don't know what it is and how to use them. My manual doesn't give me any information about ladder.
Best regards, Viktor

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Picture of 80-20 unit	dan dimock	80/20, TSLOTS and other Aluminum Framing Systems	5	01-12-2009 10:18 AM
Unit Questions	teenrocketnerd	G-Code Programing	1	06-25-2007 03:06 PM
Replacing a HF unit	amron	Welding, Brazing, Soldering, Sealing	2	04-28-2007 08:57 PM
Need Laser Unit	watzmann	Laser Engraving & Cutting Machines	35	01-27-2007 01:07 PM
Unit of measure used	xairflyer	Carken Products (Deskam, DeskCNC etc)	1	03-30-2005 03:59 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)