canned cycles on 16t?

[DocHod]

Hi all I have a question about a 16t controller that I use , when the capII was installed in the machine to use the F.A.P.T. and years later I went to use canned cycles for drilling the controller would not acknowledge the drilling cycle , is this a parameter problem or not? any help I would be grateful thanks.

[M-man]

Ive got 18iT with Fapt2 and I can still use all canned cycles.

[bob1371]

Hope this helps.
Parameter 9929 Bit3=1 "CANNED CYCLES FOR DRILLING"
Parameter 9944 Bit7=1 "TYPE II CANNED CYCLES"


Bob

[DocHod]

Thanks I'll check the parameter Monday morning.