We are recently purchased the used Bridgeport Interact 316 Machine with
Fanuc 0 - mate F system.
System : A02B - 0100 - B501
Year 1989 / 07
While switching ON we are getting Display as
PMC Load select
(1) Load from I/O
(3) Run
(4) Run without PMC
Push 1 - 4 key
If we are selecting 1 CRT shows
PMC Loading
Address : 0000H
Data : 00H
and Just Hanging
If we are selecting 2 Display just flickering and no response
If we are selecting 4
We are getting all displays (position, parameter. DGN, Wear etc.) and we can edit the parameters.
But Nc Ready out put is not commimng & mode is not changing it is always in automode.
We are not having the Electrical Drawing & Ladder diagram to diagnose the fault.
Any body came accross the above problem pl. mail me the solution.
If any body having the Ladder & Electric diagram for the above machine Pl. mail to me. I expecting your co operation
Hi ! please check machine parametre 900 series ,..because based on my experieance P902 or P903 responsible to choosing the PMC load system ,... for example if you have PMC board M series or L series the machine parametre is difrent and also if you dont have any PMC board ,...so first thing first ! ...1- check that you have machine parametre 900 series ok or not? 2- check on control system that you have PMC board or not ?...after that let me know i help you i work for Bridegport more than 2 years !
Thank you for your Response. I checked all the 900 Series parameters in
the Machine ( Supplied by Fanuc as well as available with the Machine ). There is no PMC Board available in the system. Order made Macro only available.
This Used Machine imported from German, Now only we are switching ON the machine here.
This is for your Kind information.
ok ! please check the MEM board on this board you must have EPROM Named OE1 and may be OE2 the PMC prog inside those this Eprom ! please check thats on the boards ... because this is not an alarm this page always comes up on screen when the system unable to located the PMC prog load up !
Fanuc 0 Mate System
Reply with Quote
