0-MD Machine loses absolute coord with reset
Registered
0-MD Machine loses absolute coord with reset
I'm operating an EAGLE 1000 with a fanuc 0-md control.
Every time the reset button is pressed the absolute coordinate values change losing the g54 coord reference. The only way to bring the right coords back is to reference the axis (xyz home).
any help please Similar Threads:
Registered
Hi,
Please check that the Manual Absolute switch is on, G127.2 is showing 1.
Kind Regards
Frank Moss
Fanuc Repair
Registered
Hi Frank
I much appreciate your reply
Ive checked the parameters and the bit is set at 1
G0127 00000100
Is this right?
Ian
Registered
It is the diagnostic no (DGN) that you check press the param/dgn button twice to display dgn screen, then page down to g127.
Regards
Frank
Registered
I have the right diagnostic page g127 00000100
ian
Registered
DGN G127 bit 2 = 1 mean Absolute is on
Your machine doesn't have a Absolute manual switch but you can go to OPR page to turn it off
Ahn Vuong
Registered
SUCCESS
Thanks for the help.
It was the switch on the OPR page set wrong. THink it was the apprentice pressing buttons again!!
Once again thanks
ian
0-MD Machine loses absolute coord with reset
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules