0-MD Machine loses absolute coord with reset

[ILCORKILL]

I'm operating an EAGLE 1000 with a fanuc 0-md control.
Every time the reset button is pressed the absolute coordinate values change losing the g54 coord reference. The only way to bring the right coords back is to reference the axis (xyz home).

any help please

Similar Threads:

• Absolute cords reset in handle mode
• Need Help!- Absolute position getting reset
• Fanuc 15T Machine coord display in MM
• Coord rotation and multiple coord systems
• Absolute zero of the CNC Machine.

[moss cnc]

Hi,

Please check that the Manual Absolute switch is on, G127.2 is showing 1.

Kind Regards

Frank Moss

Fanuc Repair

[ILCORKILL]

Hi Frank

I much appreciate your reply

Ive checked the parameters and the bit is set at 1
G0127 00000100

Is this right?

Ian

[moss cnc]

It is the diagnostic no (DGN) that you check press the param/dgn button twice to display dgn screen, then page down to g127.

Regards
Frank

[ILCORKILL]

I have the right diagnostic page g127 00000100

ian

[avtechmachine]

DGN G127 bit 2 = 1 mean Absolute is on
Your machine doesn't have a Absolute manual switch but you can go to OPR page to turn it off

Ahn Vuong

[ILCORKILL]

Thanks for the help.
It was the switch on the OPR page set wrong. THink it was the apprentice pressing buttons again!!

Once again thanks

ian