g76 cycle

[Welder2022]

On a Fanuc OT, how can I set it up to use a one-line G76 cycle? Right now it has to use a two-line G76 cycle.
Sorry if this has been gone over before, but search results in this forum for G76 or OT yield nothing.

Similar Threads:

• tap cycle
• problem about cycle 19 and cycle 7, machine caculated wrong offset x and z
• Newbie- G84 Tap Cycle.
• CYCLE 83: pecking cycle with deepened starting point
• Heidenhain iTNC 530: Using Cycle 19 and Cycle 8

[ProToZyKo]

Look at parameter 0001#1

[sinha_nsit]

0 for two-block
1 for one-block
But, two-block is better, as it provides more flexibility, except in feed angles where one-block allows one deg variation. Also, alternate flank cutting is not available with two-block format.

[sinha_nsit]

If interested in detailed information about two-line G76 as well as other threading cycles, one may like to look at this.