Ok so I have this rockford planer mill that was retrofitted with a 0MC control sometime in 1995. the control was removed from a Cincinnati 25 hc with a serial number of 178. the machine was moved recently and lost its parameters. I have been tasked with trying to get this machine operational again. yesterday the machine wouldn't do anything but I changed parameter 905 bit zero to 1 and the drives actually came up getting rid of the 401 (vrdy) alarm. At this point I'm not sure if the rest of the settings and parameters are correct. I am new to FANUC as far as this stuff goes but we are making progress. I'm going to attach the information I have gathered on the equipment thus far, and I am hoping someone out there can provide some insight to this issue. maybe someone has a set of parameters off a similar control. thank you in advance!

Peter Swartz
Cowlitz River Machine
503-754-3104

Fanuc 0Mc


Main board: A20B-2000-0170/07B
SERIAL NO: 3200000877


DISPLAYED ON SCREEN AT STARTUP: 0469-05
PMC N112-01




MEM: A16B-2201-04A


I/O BOARD: A16B-1212-022


AXE BOARD: A16B-2200-0390/09B


POWER UNIT: A16B-1212-0100-01
MFG NO: P53P00922




SERVO AMPLIFIERS


X: A06B-6066-H006 A2
NO. ES20264


Y: LOOKS THE SAME BUT THERE IS NO TAG


Z: A06B-6066-H006
F3X 00897 A2


SERVOS


X


5MM/ MOTOR REV
MODEL 30S
A06B-0590-B074 #7008
DATE 94 01
TRQ (STALL) 37Nm
AMP (STALL) 16A
INSULATION CLASS F
EXCIT PERM MAGNET
VOLT 156V
3 PHASE
8 POLES
1200RPM
AMB 40 DEG C
PULSE CODER


Y


5MM/ MOTOR REV
MODEL 20S
A06B-502-B074 #7008
NO C94ZA1373
DATE 94.12
TRQ (STALL) 23Nm
AMP (STALL) 20A
EXCIT PERM MAGNET
VOLT 146V
3 PHASE
8 POLES
AMB 40DEG C
PULSE CODER


Z


2.5MM/ MOTOR REV
MODEL 5S/3000
TYPE A06B-0514-B574#7008
NO C94ZC3189
DATE 94.12
TRQ (STALL) 5.9Nm
AMPS (STALL) 10.2A
INSULATION CLASS F
EXCIT PERM MAGNET
VOLT 107V
3 PHASE
8 POLES
3000 RPM
AMB 40 DEG C
PULSE CODER

Similar Threads: