Hey guys, hope one of you can help me.
Its very important to me.
Sorry for my bad english , i am writting you from germany.


My Problem is , that i have no parameters for the spindle orientation for a Drill Tape Model T from 1990.
If you have them can you send it to me ? or can you explain how i have to do a spindle orientation.

I was looking at the internet , but i didnt find them.
somebody writes about 6xxx paramters , but i dont have it , and somebudy write about pots on the spindle drive, i try to fix the problem but i dosent work.

Hope you can help me.....