Ok so I know the routine on this and the "go talk to your dealer". I need to have a few options turned on. I have the parameters numbers I need and I have the 3 passwords. I have no clue where to put these passwords in. The control is a Fanuc 18i-MB built 2005. I can see the option parameters and when I select to change the bit it does nothing. I also tried to load the parameters through a card which didn't work. Is there something I am missing here? The dealer quoted the options but can't install for 2 weeks and I need this machine running now. Any advice and guidance would be greatly appreciated.
Dear bro.
Can you share with me the procedure for re-entering the options parameter of the Fanuc 18iMA controller?
This is my email: vanthuongeba@gmail.com.
I am very grateful for your support.
Best Regards.