Hello!!
I have problem with kitamura mycentre0b with fanuc 10m.
When i change battery, on the screen i threw:
RAM PARITY ERROR
What to do? on the screen I threRAraon the screen I threwon the screen I threw
I have some questions regarding this.
I see all the time people requesting parameters for this and that machine.
If they are indeed unique and unrecoverable, in that instance, how does one go about re-establishing what they are from scratch given a parameter manual for that control, and a reasonable notion of what hardware they have, option parameters aside?
Is this an insurmountable task?
If so, is there anywhere we who have them backed up for a particular machine could upload them somewhere to some kind of public archive?
1:"Is this an insurmountable task? " Not for the NC (control) parameters, but very time consuming and difficult. When the machine turned on at the factory for the first time, it was loaded with a basic set of parameters and then fine tuned. When it was commissioned at the customer, more fine tuning was done to satisfy the customer. Over the years changes were made and,unless recorded, will have to be recreated. Th PC (interface) parameters are an integral part of the ladder program and are not in the control manual.
2: "If so, is there anywhere we, who have them backed up for a particular machine, could upload them somewhere to some kind of public archive?" That has been done to a limited extent. The problem is: who is willing to pay for what? There is a large percentage of CNC users who don't know about the need to have recent back-ups, or even how to do that. Who will take on that responsibility within the company and pass it on in case they are unable to do so? It 'should' be a defined task within the company, but rarely is.