Originally Posted by
BIBOZ65
Hi to all, I have a problem with fanuc control. So 3 weeks ago I buy a machine DART VMC 800 fully functional. Tha machine arrive at my company, connected, everything was ok, I didn't use the machine, Machine was disconnected, 2 weeks for clean all parts, yesterday the machine has been reconnected and appear on the spindle display module "AL19" that say exceed power supply to the "u" phase.
module spindle is : A06B-6078-H211#H500.
I turn on the machine and appear 00 and immediatly AL19, after some seconds only 2 lines blinking.
If I on the machine from the panel board show me a 408 alarm serial not ready. I have a lots of dubs because no other signal receive from machine.
The fan of spindle motor turning.
I post some photos for have better help as you can.
Thanks for help me.