Fanuc OM AXIS INTERLOCK


Results 1 to 4 of 4

Thread: Fanuc OM AXIS INTERLOCK

  1. #1
    Registered
    Join Date
    Apr 2009
    Location
    Puerto Rico
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Fanuc OM AXIS INTERLOCK

    Recently I purchase a Supermax 1 Rebel, Changing the parameters for use a DNC software accidentally turn off the machine before restore the PWE to 0. When I restart the machine I cant move any axis and it show a massage " axis interlock". I need help! Thanks Folks!!!

    Similar Threads:
    Last edited by RoblesTig275; 04-19-2017 at 12:38 PM.


  2. #2
    Registered
    Join Date
    Apr 2017
    Location
    United States
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc OM AXIS INTERLOCK

    Hold "P" key and "CANCEL" at the same time, power on the control, this should remove the alarm and allow you to move the axes away from OT switch.



  3. #3
    Registered
    Join Date
    Apr 2009
    Location
    Puerto Rico
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc OM AXIS INTERLOCK

    Cincyice58, Thanks a lot!!! The cnc is moving again!!!



  4. #4
    Registered
    Join Date
    Apr 2017
    Location
    United States
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc OM AXIS INTERLOCK

    great to here



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Fanuc OM AXIS INTERLOCK
Fanuc OM AXIS INTERLOCK