1 Attachment(s)
Re: Takisawa TC-1 Fanuc 0-TC
Hi Bip,
below is a backup of my parameters, I hope that will be the same for your machine as well. As far as I know, they are mostly all the same hardware and machine options. These are old, simple machines and there should not be too many differences between the machines.
Re: Takisawa TC-1 Fanuc 0-TC
Thankyou bobancurug for your reply, it's much appreciated.
These parameters have helped and have me closer to getting this machine running.
My next issue is i think the machine is set to an 8 tool station, however we have a 12 tool. I'm thinking that this may be set through one of the diagnostics. I can MDI T0101 through to 8, however 9-12 do not work. I found someone who sold me the parameters/diagnostics for other machines that are similar, however as i look at the supplied photos, all these machines have an 8 tool turret.
Any ideas?
Re: Takisawa TC-1 Fanuc 0-TC
[QUOTE=bip1988;2482658]Thankyou bobancurug for your reply, it's much appreciated.
These parameters have helped and have me closer to getting this machine running.
My next issue is i think the machine is set to an 8 tool station, however we have a 12 tool. I'm thinking that this may be set through one of the diagnostics. I can MDI T0101 through to 8, however 9-12 do not work. I found someone who sold me the parameters/diagnostics for other machines that are similar, however as i look at the supplied photos, all these machines have an 8 tool turret.
Any ideas?[/QUOTE]
D435.7 will enable the 12 station turret.
FYI holding EOB while pressing output will punch out the 900s
Re: Takisawa TC-1 Fanuc 0-TC
Thank you, confirmed this worked.