Originally Posted by
jrick
I am a new member. I posted this in the club house and maybe tht was the wrong place. I currently use MDI to start up machine. I enter
m91 m28 x0 y0 z-1.5
then
m94 t13
m97 t13
I have andi router. fanuc control
the problem is after this I manually move tool from carousel to spindle, at the end of shift I move it back to carousel. I had a near miss spindle was not stopped. to avoid this I would like a program to run at startup that does above and moves the tool. Then a program for end of shift that moves to center of table and removes tool. as this is what our procedure says we should do.