| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-05-2007, 01:45 PM
| |||
| |||
Hi. I recently moved our Miyano and now It wont run. Ipress start and no hyd. come on but I get an alarm 401 servo. I press reset but it just clicks in the panel and the alarm comes up again. any ideas please. Gasher  |
|
#2
02-05-2007, 02:29 PM
| ||||
| ||||
| It helps if you give the the controller, If your hydraulics are not on then you don't have any power probabally to the servo's either, check the term 5&6 of the servo board if 110v missing, then you have a e-stop power problem more than likely. You need to get the schematics out and do some logical trouble shooting. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
#3
02-05-2007, 02:36 PM
| |||
| |||
| Al the Man Thanks for your reply. The control is 6 T Hope this means something to you. Gasher |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RS-232 Setup for Miyano w/Fanuc OT | JerryH | Fanuc | 17 | 01-20-2012 07:17 AM |
| is a miyano mtp-3 non existant ? | dt38k | CNC Tooling | 0 | 12-20-2006 08:29 PM |
| RS-232 Connection Miyano w Fanuc OT | JerryH | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 12-27-2005 08:13 PM |
| Miyano Live-Tool | JerryH | G-Code Programing | 2 | 10-26-2005 07:50 AM |
| Miyano BND-34S Programming Help | JerryH | G-Code Programing | 1 | 10-09-2005 08:11 PM |
| | |
Linear Mode
