tool setter parameter on funuc 21i-T

[wiredude]

I replaced my tool setting sensor and circuit board on my daewoo puma 230 lathe. I set parameter 5016 correctly, which is the offset for the OD cutting, But now I'm getting about a .063 differance when I use a boring bar. Is there a different parameter I need to change to calibrate the ID boring operation? If so which one and how to.

Wiredude

[xavierdemoura]

Wireude,

I don't remenber now whith precision, but i know that are 4 parameters to change. 5014, 5015, 5016 and 5017. In the parameter manual has correctly. But i know that 5014 and 5015 are OD (x and z), and 5016 and 5017 are ID (x and z). Confirm that.

Best regards.

[udrııl79]

........o i controller

probe direction
+X ,....-X ,.... +Z ,... -Z
5016 , 5015 , 5018 , 5017


.........o t controller

probe directions
.+X ,. -X ,. +Z , ..-Z
744 ,. 743 ,. 746 , 745

[dcoupar]

Maybe this will help.