Fanuc 9M data transfer problem - CNCzone.com-The Largest Machinist Community on the net!

YOO · #1 12-29-2006, 10:36 PM

I have YASDA machine with fanuc 9m control system. And when it comes to transfer the NC program through a rs232c cable, NC send only one block and the PC says "transfer finshed" but push the PUNCH key then the machine send one block again. what is the problem?
when it comes to send PARAMETERS, there is no trouble.

YOO · #2 01-18-2007, 08:26 AM

I finaly found out the reson why.
I have tried to replace from the 1st parameter all day long.
Switching the param #6.5 to "1" the problem was solved.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)