z axis stroke limit on fanuc wire edm - CNCzone.com-The Largest Machinist Community on the net!

REVCAM_Bob · #1 12-22-2006, 01:03 PM

Looking for variable or setting that we can set from within a program
that sets the z axis limit. We can set it manually, but do not know how to
in a program. Tried g22 but it only sets limits for x, y axis.....
Control is a Fanuc 180is-w

Thanks!

limet43 · #2 05-22-2011, 11:24 AM

You need to install a G53z-2.500 (fill in what the stop is). The program has to be done in Absolute though, if its done in relative it will not recognize the G53

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)