Fanuc Oi rapid traverse problem

[longcut]

Was wondering if anybody had any ideas on a intermittent problem with the tool going into full rapid traverse (even though the rapid traverse over ride dial on the control is set at 50%) during a cycle ...most of the time after a tool change?
If it does it at the end or the program and sees M30, the new cycle is ok. If it does it prior to changing to another tool in the program it will rapid full speed, orientate the spindle and stop? No tool change, no error message cycle light is lit and if I hit reset all is fine for a little while?
Control is on a Sharp sv2412 vmc Thanks

[timlkallam]

I sorry to here this I also have a sharp 2412 .Call Charlton
Lou at sharp he is there tec. Please keep us posted on the outcome.

[longcut]

Hi Tim, finally got a hold of Charlton today and he is sending me a new (M06)tool change (9001) macro. He asked asked how old it was (2003) so maybe they found something in their macro/software that didn't agree with Fanuc Oi.
Hopefully it won't turn into a witch hunt Later, Matt