Takisawa not working properly after exhnge mainboard

[erikturn]

Hello am I in the right place

We changed the mainboard Takisawa TC-2 lathe A16b-1000-0010/f8 to a working unit , what we did not know is that the new board came from 6 station turret machine and ours is 8 station machine . Is it possible to change this new board
to work as a 8 station machine .Now it gets confused after 6th station
any help appreciated
Also when we run the machine in auto mode it stops at M68 chuck close and just hangs, same thing happens when when I change over to M69 (it used to work with the old board)



any help Thanks

[JIMMYZ]

Hi erik,
check the fanuc parameters. usually a keeprelay change denotes which type of turret. my daewoo is the same way.

jz