Fanuc 0T Serial port problem - CNCzone.com-The Largest Machinist Community on the net!

a_greavu · #1 10-12-2006, 05:49 AM

I have a Fanuc 0T CNC with a defective first serial port (connector M5). Is there a way to enable from software the second serial port (conn. M74)?

Al_The_Man · #2 10-12-2006, 06:53 AM

Set input channel to 2.
parameters 0050 & 0250 apply (0250 for baud rate)
Al.

a_greavu · #3 10-12-2006, 10:08 AM

I've already tried the settings you recommended but it's still not working. I've seen on another thread about Fanuc 0M the fourth bit of 914 must be set. Is this valid for OT as well?

Al_The_Man · #4 10-12-2006, 05:31 PM

I show it valid for 0M.
Al.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)