Oi subroutines help

[mishikwest]

I've got three deep subprogram ,#0001, 0002, and 0003.
I can't get 0003 to call 0002 more than once, it should be calling it 10 times.
Any ideas?


Main part program:

%
O0001(CAP)
( CAP)
( 24-07-06 )
G20
(TOOL - 1 OFFSET - 1)
(1 VNMG .03 INSERT - VNMG-332)
G0 T0101
M8
G97 S2500 M03
....
....
....
....
....
/M30
M99
%

Running that program 6 times with an incremental advance and bar pulling:

%
O0002(CAP X 6)
(7/8 BAR)(3.00)
G10P0Z16.750
M98 P0001
G10 P0 W.450
M98 P0001
G10 P0 W.450
M98 P0001
G10 P0 W.450
M98 P0001
G10 P0 W.450
M98 P0001
G10 P0 W.450
M98 P0001
N0707(BAR PULLER)
G00 G40 G99
M05
M09
T0700
X3. Z-.625 T0707
G01 G98 X0. F300.
M16
G04 U.5
W2.750 F100.
M15
G04 U.5
X3. F300.
G00 G99 X8.0Z6.
T0700
/M30
M99%

Trying to run 0002 ten times with this program, but it only runs it once

%
O0003
M98 P100002
M30%

I've run that exact same program (#0003) on a differnt file, and it works great for multiples. It's something do to with that program #0002 I suspect? Also tried
%
o0003
M98 P0002
M98 P0002
m30

and upon returning to the 0003 program, the control acts like its in single block mode. Each press of start will advance the 0003 program.

[xavierdemoura]

Man,

You need put M98P0001L10. L10 means that you will do the subroine 0001 ten times.

Daniel