Need Custom macros for Fanuc 3M

[brgrii]

Well, I am a month or two into figuring out my mill, and I see in the Fanuc manual that it came with some nice canned programs (macros for Bolt Hole patterns, pockets, etc - 8 in all I think) that are no longer resident in the control memory (it was in storage for 6 years). Can anyone tell me where to re-aquire the code I can input to re-enable my machine to run these macros? I suppose I could spend a few weeks re-inventing the wheel here, but I have to believe this code is availble out there somewhere.

Thanks for any help.

[CNCRim]

I is an option you have to buy. If you didn't buy this option I don't think you can use these feature. One way to test if these option is go to MDI and type in G-code you intend to use....... if an alarm pop up, you are out of luck.