Murata wiedemann Centrum 2000 turret punch, Fanuc 0p controller

[DALLAS-CPT]

Greetings all!!!

Is anyone having the papers of the special parameters. its a A4 list of the parameters, says for example no. 071 turret chain, 122 index..............
I miss them for years and i need them to recalibrate the machine time to time

If anyone have a centrum 2000 please give a hand

I also have a good experience in repairing the machine in case anyone is having any problems

Thanks
Dallas

Similar Threads:

• Anywhere to get ladder for Murata Centrum 2000 eproms?
• Need parameters for Murata Centrum 2000 turret punch (Fanuc 0p B controller)
• Need Help!- Wiedemann CENTRUM 2000Q - FANUC 6M Can't zero set.
• GE 1050 controller on Behrens Turret Punch

[maianh13]

Need Help: muratec 1544 punch laser
I thank you so much for video which I watched it many times . I bought Muratec Hibrid Flexi Laser Machine Model 1544 three years ago from Japan ( MY 1997) for sheet metal job but I failed to run machine. I really need your help and guide.
I am ready to bear all charges if you can help us to run the machine. I am looking forward to hearing from you at your earliest convenience.
1123 A10.3: Laser Oscillator not ready ( Laser Oscillator Not Started yet due to bellow alarms )

[cah]

Dear Dallas,

Do you have operating manual for Centrum 2000/Q?
Which software do you use for NC output?

Please support me

Regards
CaH

[DALLAS-CPT]

operation manual is like a book..... what do you want to know

[cah]

Dear Dallas,

Unable to communicate by DNC, I want to know pin outs for RS232C cable & parameter setups
Do you have post for CNCKAD?

WIEDEMANN CENTRUM 2000 Q,
Max. pressure T 20,
Max. thickness mm 6,35
Depth of throat mm 1020,
Strokes per minute n° 420,
Tool turret n° 22 (2 index)
Max. working dimensions mm 1270x1030,
CNC Fanuc op

[cah]

Dear Dallas,

I tried a lot for DNC setups, Could you please support me?

Regards
CaH

[JRAMON17]

SOMEONE COULD SEND ME A PHOTO OF THE HYDRAULIC SYSTEM CONNECTION, PLEASE.