Fanuc OM

[majstr]

I would like to know how to send Macro files(O9000-O9999)into controler. Which parameter must be change to allow transmition? Thanks majstr

Similar Threads:

• Need Help!- Fanuc drill tap center equipped with Fanuc OM-C i/o card details
• Fanuc <--> Heidenhain encoder converters on Fanuc 21 control?
• pro engineer post processor fanuc 18i mb5 and fanuc 180i Ma
• can fanuc ac digital servo amplifiers be run by a controller other than fanuc?

[Bluesman]

I would like to know how to send Macro files(O9000-O9999)into controler. Which parameter must be change to allow transmition? Thanks majstr

Check P# 3202 See if it has NE8 and NE9, Now I am not sure of this goes for an OM or not but FANUCs do not change a whole lot as far as that one. It is the same on a 6 all the way to 21. If you show these then you need to turn them off (from 1 to 0) Be sure and turn PWE on first to change them.

Bluesman

[manonkampeera]

Help me, How to repair cnc Fanuc OM This machine cannot change tool He Show Error code P/S alarm 099. And Input Output data not work also
Thank you...

[spark-el]

Set parameter 389.2 to 0 for 8000 programs, and parameter 10.4 to
0 for 9000 programs. This allows output or editing of these ranges.
You should be able to upload (computer to cnc) 9000 prgm without
the parameter set. Must be in edit mode with data protect key turned
to off.