0-MD: I'm gettin it but...

[andycapp]

Ok, as far as i can tell, dia. and tool length are in the same list. I just have to use diferent nubers for d and h (T1 H1 D51)?
Is there a tool "catalog" somewhere that I can see what tool is what pot, and/or edit tool #'s?
How can I see current (h1,h2,h3) tool height instead of absolute height (always my referance toool t1-h1) while running a program (or any other time for that matter!

[dpuch]

Yes use different numbers for D and H like you mentioned.

I have an Excel (0M control) with 24 pockets It uses paramaters 601-624 for pockets 1-24
600 for the tool in the spindle
598 for the tool in the ready pocket (pot swung out for tool change)
599 for the POT # that is swung out

Dale