Need help with PC Parameters on a Fanuc 6M - Page 4 - CNCzone.com-The Largest Machinist Community on the net!

nguyenthanhthi · #37 06-12-2008, 08:26 PM

Is your machine punch press. Push emergency then do it

PhoenixMetal · #38 06-12-2008, 10:21 PM

Thanks - I have tried two different ways to put the machine into emergency mode, however it still will not go into MDI mode.

I once managed to trick the machine into thinking that the turret was zeroed, but I cannot seem to duplicate it.

Any other ideas?

airport · #39 01-06-2011, 02:53 PM

in the back cabinet you will find th OD board on this board you will find the emergency state parameter switch(esp)
this switch will allow you into MDI mode

involutetools · #40 02-15-2011, 10:59 AM

Hi All,

We have a Bridgeport 320H with a Fanuc 6MB controller. We have lost our parameters & are unable to run the machine.

Could you please help us in getting the parameters. You may email us at involute@airtelmail.in

Thank in advance.. Regards

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)