Need the variable types for Arc on Fanuc 21 T

[Desertrunner]

I have a Takisawa lathe with a Fanuc 21-T controler what I was wondering is if anyone could tell me what the variable that need to be supplied to program the G Code for Arc CW & Arc CCW also any others that happen to be important for this controler.
I am using CamBam and have to configure the Postprocessor for the job.
Tony

[fordav11]

to cut circular interpolation CW G02 X.... Z..... I...... K...... R......
to cut circular interpolation CCW G03 X.... Z..... I...... K...... R......
if you use I and K omit R
if you use R omit I and K

any others.... well you could start by reading a Fanuc manual. There's several hundred pages of important things. Far too much to go into general details here.

[Desertrunner]

Thanks I appricate that, my manuals and machine are still to be delivered and I am trying to set up a postprocessor in CamBam that is why I asked the question, maybe I need to be a bit more patient. Thanks again,
Tony

[fordav11]

you can get the 21i-TB manual here......
http://www.prodsa.com.ar/integradore...0B/63604EN.pdf