The idiot engineer at Tsugami decided that M5 should turn off the spindle AND coolant *facepalm*. Is there a parameter to disassociate these 2 actions? or is that written into the ladder?
It wold be nice to be able to write M5 instead of S0. When you command S0 the spindle motor tries to hold the position that it stopped at and alarms out if you move it even by hand which normally doesnt matter but for setup it can be annoying.
Its a 18i-TB control if it matters.
Process Development machinist / Swiss Programmer / CNC training consultant / Aspiring to be a Swiss Process Engineer, Applications Engineer or machine tool sales
look into ladder. may be turning off keeprelay just needed
Consultations on repair the hardware of CNCs, drives. Ladder editing.
E-mail, Skype, PM