| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-21-2012, 09:06 AM
| |||
| |||
Hello, we have older IKEGAI lathe with Fanuc 18T controls. During cutting lathe stoped and we can't figure out why. We checked overtravel switches even moved machine manually over - nothing. Any ideas?? -EMG- in flashing on the screen and alarm light is on. Thank you,  |
|
#2
01-21-2012, 09:31 PM
| |||
| |||
| You will need to refer to machine builder's(NOT Fanuc manual) electrical wiring diagram and see what else is tied to Emergency stop circuit. I have seen anything from lube pump overload to air pressure low tied to EMG circuit. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flashing MF1 Button? | Wheelz | Mazak, Mitsubishi, Mazatrol | 0 | 10-12-2011 02:26 PM |
| Need Help!- No LSK Flashing on Fanuc 0M-B | ixoxi999 | Fanuc | 1 | 09-08-2010 12:30 AM |
| Flashing | hjl4 | Viper Servo drives | 1 | 07-07-2010 10:50 PM |
| Need Help!- TEK10 red LED keeps flashing | bartL | TEKdrive Servodrives | 2 | 10-19-2009 03:10 PM |
| Need Help!- Flashing bit | mr_electrician | Fanuc | 3 | 02-15-2008 01:19 PM |
| | |
Linear Mode
