fanuc control 10t machine error lamp on

[Asfar]

Ihave to upload parameters: IPL screen passed then machine on with MDI mode but i can not change mode (such as Jog, edit, rapid..). screen shows some alarm as below
sv026 X illegal axis arrange
sv027 x ill dgtl servo parameter
sv027 x ill dgtl servo parameter
ot100 spindle alarm

as well machine error lamp in on.

i tried to give some parameter in MDI Mode manually. but i could not found those paramenter number which i need such as (1023,.....etc...)

IPL screen
May i know while after input 99 machine ask axis?
what number i need to give? just 2 only enough.. or anything else..

waiting for your kind reply.

[fordav11]

for a lathe axis = 2

ignore the alarms.
you wont be able to exit MDI until all parameters are input (incl. PMC parameters). or at least enough to make the machine work.
for now input all common parameters then power machine off/on and see what happens.

[Asfar]

how can i input parameters in MDI mode. because there is no softkey function punch which is only edit mode. if MDI mode okay, please tell me the procedures how can PMC parameter input the machine

why some parameter numbers there is no in our machine.

thanks for your replay. again i am waiting for you

for a lathe axis = 2

ignore the alarms.
you wont be able to exit MDI until all parameters are input (incl. PMC parameters). or at least enough to make the machine work.
for now input all common parameters then power machine off/on and see what happens.

[fordav11]

follow the restore procedure here.
http://www.kfasllc.com/memory_backup_restore_F1011.htm

[gbowne1]

Ty for the procedure.

Things like this help.. especially not having any of the 10/11/12 documentation & manuals.

[Asfar]

follow the restore procedure here.
Fanuc 10 Fanuc 11 Memory Backup Procedures

Really very useful this link. Now our machine 90% okay, still i,v to short off few, becoz Now show this alarm message in crt 0344 turret parameter error then i check data table control there there is no these address d108 and d109 so how can i solve ths problem? i uploarded these pArameter PMC, pitch, paramete and manually put data table, keep relay, counter, timer. Is it okay or else?

[Asfar]

Yes i followed up now okay i can restore parameter through rs232 cable. when read parameter machine, suddenly show this message parameter looked, what is the reason? help me please

follow the restore procedure here.
Fanuc 10 Fanuc 11 Memory Backup Procedures