Workshift (Fanuc OT) X value

[mousongie]

Hi Mates,

Can someone takes me step by step, to how to assign the Workshift of the X axis on a Fanuc OT.
When i open the Workshift page, im presented with X,Z values on the left and right side. Please help me to set the X value.

I also take profit of this occasion, to thank again all the guys who helped me to understand how to to assign the Z Workshift on Fanuc Oi TB.

Thanks in advance.

[fordav11]

Leave the X at 0
Set tools as usual in geometry page.
i.e. touch on a diameter of the part, measure the OD (we will say it is 123.456), in geometry page for that tool in X position type X123.456 and press MEASURE. Repeat for Z by touching the same face you touched when setting Z workshift
repeat for all tools X and Z