Need Help! Fanuc S Series Spindle Drive - CNCzone.com-The Largest Machinist Community on the net!

Dave3891 · #1 11-22-2011, 09:05 AM

I am looking for a manual for the Fanuc S series spindle drive (A06B-6059)

I need to know the pin out of the CN1 to interface it with my machine that is non fanuc.

It was interfaced before but I am changing the wiring and I dont know the pin out of this drive to interface it.

Thanks
Dave

GPena · #2 11-23-2011, 11:57 AM

I hope this helps you...

Good luck.

GP.

Dave3891 · #3 11-23-2011, 01:47 PM

Thank you!

Do you happen to have the definations of the pin out as well?
I am not sure of some of the symbols.

Thanks
Dave

GPena · #4 11-23-2011, 06:05 PM

Sorry Dave, but in the manual there are no definition of the signals.

GP.

Dave3891 · #5 11-23-2011, 07:49 PM

Would you be able to tell me if all the inputs on this connector (minus the speed signal) are 24 volt?

GPena · #6 11-24-2011, 10:33 AM

All control is performed by 24V DC...

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
spindle orient fanuc 15 series	tleck	Fanuc	6	02-18-2011 08:03 AM
FANUC OT B Spindle rpm fluctuating and causing 1008 Spindle Drive Fault	Bill Gillen	Fanuc	4	10-15-2010 01:10 PM
Need Help!- Spindle drive / motor on Series 2 Mk 1	simonrafferty	Bridgeport and Hardinge Mills	0	08-17-2010 04:53 PM
Series 1 MK2 spindle drive power	colin1544	Bridgeport and Hardinge Mills	0	09-19-2008 11:55 AM
Fanuc axis drive control PCB- S Series	M.RISHIKESH	Fanuc	0	12-04-2006 10:25 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)