| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-22-2011, 06:36 AM
| |||
| |||
Dear All We have got Mitsubishi VMC with Fanuc 21MB Part count, which appears at the bottom of Position Screen, is not getting updated Please let us know on how to activate this so that at the end of ever Auto cycle, part count will increase by 1 Best Regards, M. Rishikesh  |
|
#2
10-22-2011, 07:29 AM
| ||||
| ||||
| check parameter 6700 bit 0 (PCM) & 6710 6700 Bit 0 M code that counts the total number of machined parts and the number of machined parts 0 : M02, or M30, or an M code specified by parameter No.6710 1 : Only M code specified by parameter No.6710 6710 M code that counts the total number of machined parts and the number of machined parts [Valid data range] 0 to 255 except 98 and 99 The total number of machined parts and the number of machined parts are counted (+1) when the M code set is executed. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Doosan Puma 2000sy fanuc 31i control Machine stop when required part count achieved | MSFAB | Daewoo/Doosan | 6 | 01-30-2012 09:34 PM |
| What is important part count or utilization | chrisryn | General Metalwork Discussion | 31 | 07-15-2009 03:06 AM |
| Encoder Count | Billiam | Servo Motors and Drives | 1 | 03-16-2009 09:20 AM |
| A light-weight table/bearing assembly with a low part count. | greybeard | Linear and Rotary Motion | 12 | 11-09-2005 05:16 PM |
| A light-weight table/bearing assembly with a low part count. | greybeard | Test Forum | 0 | 11-05-2005 04:28 PM |
| | |
Linear Mode
