Problem- Fanuc OM ATC parameter problem

[techscan]

My ATC is not working and holding up the machine from running. Is there a parameter setting that allows me to bypass the ATC by telling the PMC that there is no ATC attached to the machine? I can change tools by hand for now until I get it fixed.

[fordav11]

there is an ATC parameter in the PMC to tell it there is no ATC but to know what it is you will need the *machine-specific* manual listing the PMC parameters for your machine. If you tell us the machine type/model maybe someone out there has the same machine and could look in their manuals

[chucker]

I would think it would be a keep relay your looking for not a parameter just guessing.

[fordav11]

they *are* the PMC parameters. There's C, G, K, H and others. Accessed via System/PMC. All those settings are machine-specific and not listed in any Fanuc manuals.

[gbowne1]

Whats wrong with the ATC?

Tell us more about your machine.

Yeah, it could be a Keep Relay.

But yeah, the PMC parameters are mostly "Machine Specific" so you have to find them from a machine like yours, but sometimes they require a little fine tuning.