Fanuc OT - CNCzone.com-The Largest Machinist Community on the net!

stuartsr · #1 09-01-2011, 03:29 AM

Can anyone tell me how to run a repetitive sub programme on the OT system? the 10T system I'm used to just needs an 'L' then the number of repetitions in the M98 line. This cant be done with the OT system. Is it done using a setting parameter? If so can anyone tell me the number?

drdos · #2 09-01-2011, 07:50 AM

Look at this PDF file. It should explain what you are asking.

dcoupar · #3 09-01-2011, 11:44 PM

M98 Pnnnnpppp where nnnn= number of repeats, pppp= subprogram number.

M98 P101004 calls O1004 10 times.

stuartsr · #4 09-02-2011, 02:34 AM

Excellent help folks. Much appreciated. Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE Fanuc & FANUC proprietary posts	CNCadmin	Fanuc	44	01-05-2012 08:54 AM
Need Help!- Difference between Fanuc 0i-MC and Fanuc 0i-MD	humak16	Fanuc	12	12-29-2011 10:49 PM
FANUC & GE FANUC Repairs	RRL	Product Announcements & Manufacturer News	1	04-17-2011 11:50 AM
can fanuc ac digital servo amplifiers be run by a controller other than fanuc?	js412000	Servo Motors and Drives	5	03-09-2011 09:11 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)