Need Help!- FANUC O-PC system error on-power up

[cormas]

I have a FANUC 0-PC (model A02B-0098-8511) that on power-up give me the following error: SYTEM ERROR 00135-02 (see the video ....)

These are are the board installed on machine

AXE-D4 A16B-2200-036
DMC-M A16B-1211-090
MEM-A3 A16B-1212-021
I/O C7 A16B-1212-022
PSU A16B-1212-0100-01
MB A20B-2000-0170

Somebody can help me ?

[underthetire]

Hope you have all the parameters backed up. Your going to need to re-initialize the control, and hope it comes back. If not, your going to need a module.

[cormas]

Originally Posted by underthetire Hope you have all the parameters backed up. Your going to need to re-initialize the control, and hope it comes back. If not, your going to need a module.

I don't have any backup ... what module do you think that i need ? How I can try re-init the control ?

[underthetire]

I wouldn't even bother with the control until you can locate a parameter file for the machine. Without it, you now have a boat anchor.

[Spiker604]

It is very possible that you have a +24volt short, this will cause this alarm! I would disconnect any inputs and outputs to the control and then try to power up again. If the control powers up fine, then plug in each plug you disconnected previous and wait for the alarm to pop back up. then you can narrow it down to a particular input or output. Hope this helps !

[cormas]

Originally Posted by Spiker604 It is very possible that you have a +24volt short, this will cause this alarm! I would disconnect any inputs and outputs to the control and then try to power up again. If the control powers up fine, then plug in each plug you disconnected previous and wait for the alarm to pop back up. then you can narrow it down to a particular input or output. Hope this helps !

Spiker604 thank you for your advice: now I have 7 holidays days so I will check when I come back to work.