Looking fot pin out on Fanuc 6TB spindle amp - CNCzone.com-The Largest Machinist Community on the net!

08-12-2011, 05:16 PM

atex57

Join Date: Jun 2007

Location: SW Wis USA

Posts: 24

Looking fot pin out on Fanuc 6TB spindle amp

permalink

As the title says, this is a integral spindle/motor driven by an A06b-6041-H105 amp. Something isn't quite right and I need to track down the signals on CN1 and CN2. The manual that came with it shows a different number of wires in the CN1 connector. It may be that the drive has been replaced and nobody made a note of it. Any help is apprieciated.

Ed.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FANUC OT B Spindle rpm fluctuating and causing 1008 Spindle Drive Fault	Bill Gillen	Fanuc	4	10-15-2010 01:10 PM
Fanuc 6T spindle speed	Splinky	Fanuc	0	04-08-2010 11:16 PM
FANUC-6M SPINDLE ORIENTATION	CHANDRU	Fanuc	5	04-18-2009 01:05 PM
Help with Fanuc Spindle motor	will_lewis	Fanuc	0	06-02-2008 07:29 AM
Problem- Spindle Motor O-TC Fanuc	suleman_mani	Fanuc	2	05-23-2008 11:13 AM

All times are GMT -5. The time now is 07:18 PM.