Need Help! Integrate Sensor into Fanuc 16m - CNCzone.com-The Largest Machinist Community on the net!

nick323 · #1 06-29-2011, 10:05 AM

I need help integrating a sensor into a Fanuc 16i-m controller on a OKK HM 60. I cannot locate any of the manuals...any help would be greatly appreciated.

Thanks,
Nick

underthetire · #2 06-29-2011, 01:17 PM

What kind of sensor? Switch, probe, safety???

nick323 · #3 06-29-2011, 01:19 PM

Originally Posted by underthetire

What kind of sensor? Switch, probe, safety???

A pressure sensor with a digital output to make sure the part clamp is closed.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Integrate Sensor HM60/Fanuc 16	nick323	OKK	1	07-12-2011 10:16 AM
Toolbreakage sensor - Help with fanuc ladder data table	Gnome	Fanuc	1	05-05-2011 04:58 PM
Need Help!- how can I integrate AB 1394 with pc control?	rooflok	Servo Motors and Drives	2	01-30-2010 02:49 AM
fanuc magnetic sensor	keithmech	Fanuc	11	05-04-2009 07:30 PM
Fanuc Magnetic Sensor Error	symage	General Metal Working Machines	1	03-07-2007 04:02 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)