| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-21-2011, 07:48 AM
| ||||
| ||||
I have an old Hitachi (1988) wire EDM that was just installed in the shop and I'm trying to get it going. It has a SP150 control on it, and I am trying to figure out some differnt codes. I know som of the basic stuff, but I was wondering if there were any M codes specific to EDM, like one for wire run, flushing on, edm power on, etc. There are buttons for these, but I was just trying to find some M codes so I can signal them from the program instead of manually turning them on. I tried M8 for flushing, but that doesn't work. Here is the control  Thanks  |
|
#2
06-22-2011, 02:04 AM
| |||
| |||
| M-codes are defined by MTB. So, you need to look into their manual, or contact them. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- G codes and M codes for Mazak Quick Turn T-2 | sauli | Mazak, Mitsubishi, Mazatrol | 0 | 05-23-2011 11:22 AM |
| Need Help!- Sanyo Step-Syn 103-807-7 Gecko 540 Wire Color Codes | Wrangler97 | Stepper Motors and Drives | 2 | 01-01-2011 10:48 AM |
| Need Help!- Need full list of G CODES AND M CODES FOR FANUC 21I | SonnyTees.com | G-Code Programing | 3 | 02-23-2010 10:27 AM |
| Specific feed speed rates for specific wood | mcArch | WoodWorking | 2 | 08-18-2008 10:36 PM |
| Are there specific router bits for specific materials? | fivefishcnc | General Metal Working Machines | 1 | 02-24-2008 07:35 AM |
| | |
Linear Mode
