| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-05-2011, 10:28 AM
| |||
| |||
Hello, I am working on a used Kuraki KBT-13E-A that we are in the process of setting back up in our shop. And I have run into a issue with Fixture offset writing from the program. Normally we use G10 L2 P# to do so, but I am getting an "Illegal G-Code" Error as soon as I try to read a G10. Does anyone know of a parameter setting that might effect the use of G10? I know I can use variables to set a fixture offset, but I would prefer to use G10 L2 as we do in our other 2 Kurakis and the rest of the shop. Any ideas are very appreciated.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 11m issue on a Kuraki VMC | cwtoyota | Fanuc | 5 | 03-04-2010 07:29 PM |
| Kuraki KV-500 | SGARCIAM | Fanuc | 0 | 03-04-2010 03:36 PM |
| kuraki KBT 1105 | caddyshack | General Metal Working Machines | 0 | 06-23-2009 09:00 PM |
| Manuals for Kuraki MH-400. | GPena | Fanuc | 2 | 02-27-2009 02:51 PM |
| fanuc 15m kuraki kbt-11wdx | livewire | Fanuc | 2 | 11-08-2006 01:12 PM |
| | |
Linear Mode
