GN6 on Strippit - Ram Down Help Please

[jetblack]

Not sure if this is correct place to post?

I have just brought a Strippit FC1000 III with a Fanuc GN6 Control

The air went down whilst running a program in test mode and the machine stopped with the ram in the down position. On my FC1000 II with a HEC 80 control there is a procedure for starting up the machine and raising the ram. Is there a similar procedure with the GN6 control?

Many thanks for any help

Terry

[alfredo_demon1]

busco los diagramas electricos y del control.
para una fc1000 111, strippit.