How would one reload parameters from mastercam into Fanuc OMC 6 controls on a Kitamur - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Machine Controllers Software and Solutions > Fanuc
How would one reload parameters from mastercam into Fanuc OMC 6 controls on a Kitamur

Fanuc Discuss Fanuc controllers here!

This forum is sponsored by:

04-01-2011, 02:31 PM

Join Date: Nov 2009

Location: USA

Posts: 60

How would one reload parameters from mastercam into Fanuc OMC 6 controls on a Kitamur

permalink

How would one reload parameters from mastercam into Fanuc OMC 6 controls on a Kitamura Mycenter1? The mastercam side seems pretty straight forward, not sure on the NC side. Also what parameter is used to set the Z home position? I’m missing most of the manuals from the machine.

Thanks In Advance,
Eric

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
reload parameters in fanuc 0m	samu	Fanuc	3	11-29-2009 10:04 AM
Need Parameters QT-35 with T-2 Controls	capefear17	Mazak, Mitsubishi, Mazatrol	2	08-11-2008 09:18 PM
How to reload window NT on Fanuc 160I Help!	genview	Fanuc	2	02-03-2008 08:45 AM
OM loss all parameters. How to reload?	teal854t	Fanuc	4	06-06-2007 08:49 PM
Best learning method - Anilam controls, Mastercam	ronglax	General CAM Discussion	0	12-31-2005 10:47 AM

All times are GMT -5. The time now is 01:12 PM.