Fanuc Oi axis display - CNCzone.com-The Largest Machinist Community on the net!

theinmoe · #1 03-08-2011, 11:57 AM

I have 2 axis Mori SL8 machine with X and Z but control is only display X value in position screen. Is there any parameter to set to show Z in positon screen. Program with X and Z run fine but no Z display. Control is Oi Model C.
Thanks.

cnc2149 · #2 03-08-2011, 12:44 PM

Check the value of par 3115 bit 0 for the Z axis.

NDPx Display of the current position for each axis
0 : The current position is displayed.
1 : The current position is not displayed.

theinmoe · #3 03-08-2011, 01:14 PM

Yep, that fixed it. Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fanuc 10M, EMG Display On, EMG Button OK, Rev 6-29	JimBoyce	Fanuc	2	02-24-2011 01:22 PM
Fanuc ot display	Sparkatron	Fanuc	1	12-09-2010 10:30 AM
Need Help!- Fanuc 21i-T Display goes blank	sjoy2833	Fanuc	0	12-08-2008 02:02 PM
Fanuc O-MD prog ck display	yoshi900	Fanuc	3	10-15-2008 05:35 AM
Japanese display on Fanuc 12M	duccnc	Fanuc	2	07-16-2008 08:49 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)