2010 Tool Not Available - Fanuc Om - CNCzone.com-The Largest Machinist Community on the net!

PPM · #1 08-01-2005, 04:03 PM

This Operator Message comes up when trying to do tool change. I was wondering if anyone might have an idea about what is wrong. What usually causes this operator message?

Thanks,
PPM

Al_The_Man · #2 08-01-2005, 04:51 PM

Obviously you have a tool changer on this machine? Operator messages are unique to a make of machine, not Fanuc, as they are written by the tool builder, It looks like it is trying to retrieve a tool that does not exist?
what is the make of machine and don't you have the alarm list?
Al.

PPM · #3 08-02-2005, 08:41 AM

Al The Man,
Thanks for the reply. I was over looking the fact that this machine has a tool change program. The program had been erased. Also the parameters were erased. Problems
fixed machine running. Again thanks for your reply.

EDM_Fixer · #4 08-24-2005, 04:22 PM

have you set the tool up in the control .. offset..or designate a tool that is in it..? Jim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)