| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-29-2010, 07:33 PM
| |||
| |||
Hello all, I've got a problem in programming an Okuma & Howa ACT3 lathe with a Fanuc 15T control... I don't know the canned cycle commands or syntax and I don't have the programming manual available. I understand that since this is an older control the canned cycle parameters are different as well as the syntax. Can anyone help me with the programming manual or tell me what the canned cycle commands are with its respective parameters. Thanks  |
|
#3
12-30-2010, 02:22 PM
| |||
| |||
| If Dave did not have the manuals for you PM me your email and I will dig up what I can. Is your 15series a model A or B PMC? I don't think it matters for the programming manual but it does for the parameter manual. Stevo |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming PLC on Fanuc 0M | MetLHead | Machine Problems, Solutions , Wireless DNC, serial port | 19 | 06-27-2011 06:47 PM |
| Newbie- Fanuc 16 sub programming | intruder II | G-Code Programing | 2 | 09-22-2010 07:11 AM |
| Fanuc programming | newcol | Colchester Tornado lathes | 6 | 05-19-2008 03:19 PM |
| Fanuc 18i Programming | jorgehrr | G-Code Programing | 4 | 09-21-2007 12:36 PM |
| Fanuc 6T Programming | Garry Neal | Fanuc | 7 | 02-16-2007 02:11 AM |
| | |
Linear Mode
