Need Help! Fanuc A20b-1003-008 - CNCzone.com-The Largest Machinist Community on the net!

alpefe · #1 11-14-2010, 04:11 AM

Hello, I have some drivers Fanuc A20b-1003-008 and need data from them, and pin connection scheme, working with +/-10v. or PWM?, thanks.

tmbruno28 · #2 11-14-2010, 09:04 AM

are you sure of your reference ???? 008 ???

What kind of pcb ?

alpefe · #3 11-14-2010, 10:54 AM

hello, the drivers you have are A20b-1003-008 and A20b-1004-088

tmbruno28 · #4 11-14-2010, 12:44 PM

confirm that complete ref is something like A06B-6058-**** , just at the bottom of the amplifier , if it's ok, this are digital amplifier, not analog one, and need to be controled by fanuc digital system

alpefe · #5 11-14-2010, 01:30 PM

I found the reference is A06B-6058-H006, I need the pin configuration and set points if it's + / -10 v. or PWM, I put a system is not Fanuc CNC

tmbruno28 · #6 11-14-2010, 01:33 PM

It's not working with +10/-10 Volts, only digital signals.
Not impossible to make it work with another system than Fanuc but very hard !!!
Good luck !!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- ALARM 1003 FANUC 0 MATE STAMA	Dragonbikes	Fanuc	5	03-15-2011 03:00 AM
Need Help!- Fanuc A20B-0008-0410 (6M Master)	alaih17	Fanuc	8	10-26-2010 08:40 AM
Need Help!- Fanuc VFD A20B-6060-H008	cha lee	Fanuc	0	05-08-2009 09:59 AM
Fanuc Drive/Servo (A20B) Question	Death Adder	Fanuc	9	04-09-2008 09:42 AM
Connection Unit Information (A20B-1003-0240)	davider	Fanuc	2	03-06-2008 09:50 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)