| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-12-2010, 07:42 PM
| |||
| |||
Hi guys! Can anyone help me with a parameter list for a Miyano BNC-34T with GE Fanuc OT (one spindle, two turrets but turret B for drills, taps, reamers only)? Mach is very old, after rebuilt and works properly but we had a problem with battery and lost all parameters. Now I have two problems: big problem with turret B. It starts but when I want to use SINGLE POINT, DRY RUN buttons and Feed Rate = 5% turret B works with full speed (at this moment turret A works very slow) and smaller problem - WEAR OFFSET shows me alarm when I want to use value over 1.0000 . It is possible send all parameters to my PC? BoKo  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- FANUC OT - MIYANO | dwilcox@km-prec | General CNC (Mill and Lathe) Control Software (NC) | 1 | 01-19-2012 10:38 PM |
| miyano fanuc 18i controlleer | terrywinstr | CNCzone Club House | 4 | 01-28-2011 10:42 AM |
| Need Help!- Fanuc 3t parameters miyano | Progress Nc | Fanuc | 1 | 11-28-2008 09:04 AM |
| Need Help!- Miyano BNC-20s with Fanuc OT | Will_0000 | Fanuc | 2 | 10-07-2008 12:11 PM |
| RS-232 Connection Miyano w Fanuc OT | JerryH | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 12-27-2005 08:13 PM |
| | |
Miyano BNC - 34T + GE FANUC 0T 
Linear Mode
